AVR8 - Arduino application build on Windows

From ERIKA WIKI
Revision as of 18:52, 21 December 2017 by G.serano (talk | contribs)
Jump to: navigation, search

Synopsys

This guide describes the how to build a first ERIKA Enterprise v3 application for Arduino UNO boards.

RT-Druid Eclipse IDE

  • Double-Click on eclipse.exe application located into eclipse folder extracted from the RT-Druid Package and than the workspace selection window will appear as shown the following figure:
Figure 1: RT-Druid Eclipse IDE workspace selection.
  • Browse the File-System to select Workspace folder and then click on the OK button to let the RT-Druid Eclipse IDE start as shown in the following figure:
Figure 2: RT-Druid Eclipse IDE welcome.
  • Click on Welcome tab-sheet close button to show the default RT-Druid Eclipe IDE C/C++ perspective as shown in the following figure:
Figure 3: RT-Druid Eclipse IDE C/C++ perspective.

RT-Druid Template Project

  • Click on File->New->RT-Druid v3 Oil and C/C++ Project menu entry as shown in the following figure:
Figure 4: RT-Druid v3 Oil and C/C++ Project.
  • The RT-Druid C/C++ Project Wizard will open as shown in the following figure:
Figure 5: RT-Druid C/C++ Project Wizard.
  • Type the name of the the project in the Project name text-box: ArduinoEE3 for example.
  • Make sure the Cygwin GCC toolchain is selected and the click on the Next button.
  • The wizard will show the window to select a project template as shown in the following figure:
Figure 6: RT-Druid Project Template Wizard.
  • Click on Create a project using one of these templates check-box to let the Template Wizard to show the available templates as shown in the following figure:
Figure 7: RT-Druid Available Templates Wizard.
  • Expand AVR8 and Arduino Uno entries and choose a desired template to instatiate: "Full Demo 2" for example.
  • Finally, click on Finish butto to instatiate an RT-Druid Eclipse project from a choosen template as shown in the following figure:
Figure 8: RT-Druid Eclipse Project.

Arduino UNO Serial Port Detection

  • Connect the Arduino UNO board to the PC via USB cable.
  • Open the Device Management of Windows executing the devmgmt.msc command locate in C:\WINDOWS\System32 as shown in the following figure:
Figure 9: Device Management.
  • The Device Management windows will open.
  • Expand the Port (COM and LTP) entry to find the Arduino Uno COM port (COM3 for example) as as shown in the following figure:
Figure 10: Arduino Uno COM port.

Additional Notes

T.B.D.

Retrieved from "http://www.erika-enterprise.com/wiki/index.php?title=AVR8_-_Arduino_application_build_on_Windows&oldid=211"