Programing targets

[nestor]

Hello,

I have just bought a FLEX FULL target with a Multibus Base Daughter Board. I'm trying tu execute de serial demo program that comes with Eclipse to send data by the RS232 bus.

My problem is when I program the target using MPLAB IDE. If I use de Debugger Mode to program and later I press Run, I can see the data correctly with a terminal program. But when I disconect the ICD2 from the target, the data that I received are corrputed.

How can I program the target feasibly? It's possible to program the target with the Programmer mode of MPLAB IDE (menu option Programmer > Program)?

Thanks!

[paolo.gai]

Sorry for the delay in the answer, the forum was misconfigured

I'll reply in the next post...

Paolo