ERIKA Enterprise Forums

Hello

for a few days i interessted in the Erika Enterprise Projekt.

I'am a little bit confused at the moment because the Erika system gives a full support for the Lauterbach Trace32.

In my situation i have the USB Microlink Interface. The link is below:
http://de.futureelectronics.com/de/tech ... NEXUS.aspx

Question 1: Is it possible to use the Erika Enterprise OS with this configuration?

Question 2: If this is possible. Where can i change the configuration to use the Microlink usb interface?

It would be great if you can answer this two question.

Thank you in Advance :)

Yes, you can,

currently Erika supports MPC5668 (single and dual core), MPC5674F and recently MPC5643L single core (DPM and LSM). I hear that some developers (maybe students) are currently using your debugger. Anyway...

1) Erika toolchain does not automatically generate script for your debugger, hence you have to write your script;
2) be carefull to set .sbss2 to zero with your script if do not use Lauterbach with our scripts and if you run your code from RAM;
3) i can check for additional infos about the support of your debugger with Erika from our contacts that are using your debugger.

Best

Francesco

About point 3...

There are some student that use Codewarrior 10.2 that supplies a tool named debug shell, which supports command-line debug. It works both under Linux and under Win, hence there should not be any problems with Erika and your debugger.

Regards

Thank you a lot for quite fast answer :)

Im new in MPC, Codewarrior and Erika Enterprise

Hopefully i will menage that.

R3bIKE wrote:Thank you a lot for quite fast answer :)

Im new in MPC, Codewarrior and Erika Enterprise

Hopefully i will menage that.

Hi,
Im new in MPC, Codewarrior and Erika Enterprise too.
Im also trying to get the OS running on an MPC5674F using an P&E Multilink Interface.
Did you find a way to debug Erika Enterprise using the P&E Interface?

THX for your answer!