Freescale MPC and P&E Multilink Interface

[R3bIKE]

Hello

for a few days i interessted in the Erika Enterprise Projekt.

I'am a little bit confused at the moment because the Erika system gives a full support for the Lauterbach Trace32.

In my situation i have the USB Microlink Interface. The link is below:
http://de.futureelectronics.com/de/tech ... NEXUS.aspx

Question 1: Is it possible to use the Erika Enterprise OS with this configuration?

Question 2: If this is possible. Where can i change the configuration to use the Microlink usb interface?

It would be great if you can answer this two question.

Thank you in Advance :)

[fesposito]

Yes, you can,

currently Erika supports MPC5668 (single and dual core), MPC5674F and recently MPC5643L single core (DPM and LSM). I hear that some developers (maybe students) are currently using your debugger. Anyway...

1) Erika toolchain does not automatically generate script for your debugger, hence you have to write your script;
2) be carefull to set .sbss2 to zero with your script if do not use Lauterbach with our scripts and if you run your code from RAM;
3) i can check for additional infos about the support of your debugger with Erika from our contacts that are using your debugger.

Best

Francesco

[fesposito]

About point 3...

There are some student that use Codewarrior 10.2 that supplies a tool named debug shell, which supports command-line debug. It works both under Linux and under Win, hence there should not be any problems with Erika and your debugger.

Regards

[R3bIKE]

Thank you a lot for quite fast answer :)

Im new in MPC, Codewarrior and Erika Enterprise

Hopefully i will menage that.

[konwi]

Thank you a lot for quite fast answer :)

Im new in MPC, Codewarrior and Erika Enterprise

Hopefully i will menage that.

Hi,
Im new in MPC, Codewarrior and Erika Enterprise too.
Im also trying to get the OS running on an MPC5674F using an P&E Multilink Interface.
Did you find a way to debug Erika Enterprise using the P&E Interface?

THX for your answer!