First steps to porting erika to mc9s12xe family

Forum related to ERIKA Enterprise and RT-Druid version 2

Moderator: paolo.gai

Locked
LelloCaputo

First steps to porting erika to mc9s12xe family

Post by LelloCaputo »

Good morning,
I would like to be able to porting of Erika on a microcontroller mc9s12xe family. Does it possible to do that, and
What are the steps to follow?
thank you very much for your support.
paolo.gai
Administrator
Posts: 877
Joined: Thu Dec 07, 2006 12:11 pm

Re: First steps to porting erika to mc9s12xe family

Post by paolo.gai »

s12 is already supported by erika2.

Just check whether the current version works on your derivative.

Check also the porting guide which is available in the wiki...

Ciao,

PJ
LelloCaputo

Re: First steps to porting erika to mc9s12xe family

Post by LelloCaputo »

Thank you Mr. Paolo for the reply. I checked on wiki that the mcu supported by Erika are mc9s12xs and mc9s12g and mc9s12g. I have mc9s12xeg384 and code warrior compiler.
I am sorry but I am very new about Erika and I don't know where begin.
Thank you for your support
paolo.gai
Administrator
Posts: 877
Joined: Thu Dec 07, 2006 12:11 pm

Re: First steps to porting erika to mc9s12xe family

Post by paolo.gai »

Dear LelloCaputo,

please check https://erika.tuxfamily.org/wiki/index. ... controller

this should be a good starting point.

PJ
LelloCaputo

Re: First steps to porting erika to mc9s12xe family

Post by LelloCaputo »

Ok, thanx. I will try to follow that procedure.
Locked