ERIKA Enterprise Forums

Hi, everbody
I'm the new user. Cygwin, CodeWarrior and MPC5643L, it work well. But I have some problem:
1. My target mcu is MPC5634M, it's not supprot by ee;
2. I use P&E Multilink for my debugging, I don't have and cannot get the Lauterbach tool chains.
I think I should transplant EE for MPC5634M obviously. Then I should make the ee work in CodeWarrior directly.
So EE, the OSEK VDX operating system must release implementations Version A. like the picture I'm not good at RT-Druid tool and OIL, so I have no idea. If anybody gives me some advice. Tks

The microcontroller you are referring to is not yet supported.

But it should not difficult to suport since z0, z4, z6, and z7 are supported (the core of MPC5634M is a z3).

The steps for implementing the support are listed in the wiki at the page

http://erika.tuxfamily.org/wiki/index.p ... controller

If you need direct support from us, please write diret e-mail to info "at" evidence "dot" eu "dot" com .

Ciao,

PJ

It's great. I will try. tks

paolo.gai wrote:The microcontroller you are referring to is not yet supported.

But it should not difficult to suport since z0, z4, z6, and z7 are supported (the core of MPC5634M is a z3).

The steps for implementing the support are listed in the wiki at the page

http://erika.tuxfamily.org/wiki/index.p ... controller

If you need direct support from us, please write diret e-mail to info "at" evidence "dot" eu "dot" com .

Ciao,

PJ