Re:FLEX Full PCB Programming with the USB
Moderator: paolo.gai
-
Tuctronics
- Newbie
- Posts: 1
- Joined: Wed Jan 30, 2008 10:23 pm
FLEX Full PCB Programming with the USB
Greetings. Is there some where I can find documentation on how to use the FLEX full PIC18 to program the dsPIC using the USB port? I do not even need Real time Kernels or C compiler at this point. Just a simple method to program the dsPIC on the FLEX and have it turn on an LED.
Re:FLEX Full PCB Programming with the USB
Hi!
Sorry for the delay... I was out of town for a few days...
We have some good news, in fact we have almost finished a plugin for MPLAB IDE which interfaces it with the USB port of the microcontroller. This will provide initial programming features.
We are also working on a programming method which uses a bootloader on the PIC18 (basically without the need of MPLABIDE).
We will release these features after the release of EE 1.4.2 together with a demo daughter board and the support for Scilab 4.1.2. The release of the new boards/Scicos/EE is planned before February 20, after that we will release the programming plugin...
bye!
PJ
Sorry for the delay... I was out of town for a few days...
We have some good news, in fact we have almost finished a plugin for MPLAB IDE which interfaces it with the USB port of the microcontroller. This will provide initial programming features.
We are also working on a programming method which uses a bootloader on the PIC18 (basically without the need of MPLABIDE).
We will release these features after the release of EE 1.4.2 together with a demo daughter board and the support for Scilab 4.1.2. The release of the new boards/Scicos/EE is planned before February 20, after that we will release the programming plugin...
bye!
PJ