Programming flash for AURIX TC397
Posted: Wed Aug 05, 2020 12:27 pm
Hello,
I have TriCore TC397XE board and i successfully managed to build demo application based on HighTec's free Tricore toolchain.
I can't debug the application on my board since both TRACE32 and winIDEA requires external hardware product (like PowerDeubg - http://www.bwz.se/nohau/UserFiles/Files ... erbach.pdf) in order to debug Erika app.
This means the only option left for me right now is to program the application to the infineon's internal flash. I converted the erika3app.elf into hex file and tried to program it using Infineon's memtool. I received the following warning: I ignored it and tried to program the flash anyway, but the RST led became red, which points on a problem.
I will mention that i manged to program hex files which were created from executable within HighTec(IDE) and AURIX Development Studio. I can add additional information if something isn't clear.
Any suggestions on how to run my demo application ?
Thx, Dekel
I have TriCore TC397XE board and i successfully managed to build demo application based on HighTec's free Tricore toolchain.
I can't debug the application on my board since both TRACE32 and winIDEA requires external hardware product (like PowerDeubg - http://www.bwz.se/nohau/UserFiles/Files ... erbach.pdf) in order to debug Erika app.
This means the only option left for me right now is to program the application to the infineon's internal flash. I converted the erika3app.elf into hex file and tried to program it using Infineon's memtool. I received the following warning: I ignored it and tried to program the flash anyway, but the RST led became red, which points on a problem.
I will mention that i manged to program hex files which were created from executable within HighTec(IDE) and AURIX Development Studio. I can add additional information if something isn't clear.
Any suggestions on how to run my demo application ?
Thx, Dekel