Ok Paolo, now I understood :)
Michele.
Search found 4 matches
- Fri Jun 20, 2008 10:44 am
- Forum: FLEX (closed)
- Topic: Burned the dsPIC 33F, it is possible replace it?
- Replies: 4
- Views: 5202
- Fri Jun 20, 2008 9:14 am
- Forum: FLEX (closed)
- Topic: Burned the dsPIC 33F, it is possible replace it?
- Replies: 4
- Views: 5202
Re:Burned the dsPIC 33F, it is possible replace it
Thanks Paolo.
So probably I will prepare an interface for the board.
Maybe for the next FLEX-Board you can think a possibility to change the DSC easely ;). Can be an Improvement.
In any case thanks for your work.
Michele.
So probably I will prepare an interface for the board.
Maybe for the next FLEX-Board you can think a possibility to change the DSC easely ;). Can be an Improvement.
In any case thanks for your work.
Michele.
- Wed Jun 18, 2008 4:54 pm
- Forum: FLEX (closed)
- Topic: Burned the dsPIC 33F, it is possible replace it?
- Replies: 4
- Views: 5202
Burned the dsPIC 33F, it is possible replace it?
Hi everybody, I think I have burned the dsPIC33FJ.. on my Full-Flex board when I was trying to acquire same analog signals from a potentiometer (I am not a beginner in Electronics, but this thinks happens if you start to interface the device with something).. I am no sure about it because seems (due...
- Mon Jun 09, 2008 9:49 am
- Forum: FLEX (closed)
- Topic: Using the ADC with Flex-Scicos Toolbox
- Replies: 1
- Views: 3021
Using the ADC with Flex-Scicos Toolbox
Hallo Everybody, Anyone of you know to which pin of the Flex-Board is mapped the input Pin:1 of the FLEX-ADC Scicos-toolbox block (pin (of DSPIC33F) 25 or 32 or 6). Also I can not find any information about the relationship between ports of the FLEX-Scicos toolbox and pins of the FLEX-Full board. I ...