Erika vm and avr8

Forum related to ERIKA Enterprise and RT-Druid version 2

Moderator: paolo.gai

Post Reply
shakthi
Newbie
Posts: 11
Joined: Mon Nov 12, 2018 9:24 pm

Erika vm and avr8

Post by shakthi » Wed Dec 05, 2018 10:05 pm

Sir, i followed the steps according to the manual provided in the desktop.
also, i have used three arduino boards, on using all these boards,the error shown is same..
avr is not responding and make target failed..
how to clear this errors and to upload the program to arduino
Attachments
makefile.jpg
makefile.jpg (1.64 MiB) Viewed 2480 times
pgm.jpg
pgm.jpg (1.09 MiB) Viewed 2480 times

paolo.gai
Administrator
Posts: 864
Joined: Thu Dec 07, 2006 12:11 pm

Re: Erika vm and avr8

Post by paolo.gai » Thu Dec 06, 2018 7:55 am

I see that you can now compile. Could you please tell what was at the end your previous problem when compiling?

The problem you have now is that avrdude is not receiving data. Did you fill the properties "Arduino Serial Baudrate" and "Arduino Serial Port" correctly?

Regards,

Paolo

shakthi
Newbie
Posts: 11
Joined: Mon Nov 12, 2018 9:24 pm

Re: Erika vm and avr8

Post by shakthi » Thu Dec 06, 2018 8:43 am

hi sir, i have encountered this problem only previously also,
i have selected the arduino sdk, serial baud rate , com port as mentioned in the manual

Post Reply