Page 1 of 1
First steps to porting erika to mc9s12xe family
Posted: Tue May 21, 2019 10:12 am
by LelloCaputo
Good morning,
I would like to be able to porting of Erika on a microcontroller mc9s12xe family. Does it possible to do that, and
What are the steps to follow?
thank you very much for your support.
Re: First steps to porting erika to mc9s12xe family
Posted: Tue May 21, 2019 10:29 pm
by paolo.gai
s12 is already supported by erika2.
Just check whether the current version works on your derivative.
Check also the porting guide which is available in the wiki...
Ciao,
PJ
Re: First steps to porting erika to mc9s12xe family
Posted: Wed May 22, 2019 7:04 am
by LelloCaputo
Thank you Mr. Paolo for the reply. I checked on wiki that the mcu supported by Erika are mc9s12xs and mc9s12g and mc9s12g. I have mc9s12xeg384 and code warrior compiler.
I am sorry but I am very new about Erika and I don't know where begin.
Thank you for your support
Re: First steps to porting erika to mc9s12xe family
Posted: Fri May 24, 2019 12:53 pm
by paolo.gai
Dear LelloCaputo,
please check
https://erika.tuxfamily.org/wiki/index. ... controller
this should be a good starting point.
PJ
Re: First steps to porting erika to mc9s12xe family
Posted: Tue May 28, 2019 6:29 am
by LelloCaputo
Ok, thanx. I will try to follow that procedure.