First steps to porting erika to mc9s12xe family

Forum related to ERIKA Enterprise and RT-Druid version 2

Moderator: paolo.gai

Post Reply
LelloCaputo
Newbie
Posts: 3
Joined: Wed May 15, 2019 2:20 pm

First steps to porting erika to mc9s12xe family

Post by LelloCaputo » Tue May 21, 2019 10:12 am

Good morning,
I would like to be able to porting of Erika on a microcontroller mc9s12xe family. Does it possible to do that, and
What are the steps to follow?
thank you very much for your support.

paolo.gai
Administrator
Posts: 864
Joined: Thu Dec 07, 2006 12:11 pm

Re: First steps to porting erika to mc9s12xe family

Post by paolo.gai » Tue May 21, 2019 10:29 pm

s12 is already supported by erika2.

Just check whether the current version works on your derivative.

Check also the porting guide which is available in the wiki...

Ciao,

PJ

LelloCaputo
Newbie
Posts: 3
Joined: Wed May 15, 2019 2:20 pm

Re: First steps to porting erika to mc9s12xe family

Post by LelloCaputo » Wed May 22, 2019 7:04 am

Thank you Mr. Paolo for the reply. I checked on wiki that the mcu supported by Erika are mc9s12xs and mc9s12g and mc9s12g. I have mc9s12xeg384 and code warrior compiler.
I am sorry but I am very new about Erika and I don't know where begin.
Thank you for your support

paolo.gai
Administrator
Posts: 864
Joined: Thu Dec 07, 2006 12:11 pm

Re: First steps to porting erika to mc9s12xe family

Post by paolo.gai » Fri May 24, 2019 12:53 pm

Dear LelloCaputo,

please check https://erika.tuxfamily.org/wiki/index. ... controller

this should be a good starting point.

PJ

LelloCaputo
Newbie
Posts: 3
Joined: Wed May 15, 2019 2:20 pm

Re: First steps to porting erika to mc9s12xe family

Post by LelloCaputo » Tue May 28, 2019 6:29 am

Ok, thanx. I will try to follow that procedure.

Post Reply