Page 1 of 1

Erika vm and avr8

Posted: Wed Dec 05, 2018 10:05 pm
by shakthi
Sir, i followed the steps according to the manual provided in the desktop.
also, i have used three arduino boards, on using all these boards,the error shown is same..
avr is not responding and make target failed..
how to clear this errors and to upload the program to arduino

Re: Erika vm and avr8

Posted: Thu Dec 06, 2018 7:55 am
by paolo.gai
I see that you can now compile. Could you please tell what was at the end your previous problem when compiling?

The problem you have now is that avrdude is not receiving data. Did you fill the properties "Arduino Serial Baudrate" and "Arduino Serial Port" correctly?

Regards,

Paolo

Re: Erika vm and avr8

Posted: Thu Dec 06, 2018 8:43 am
by shakthi
hi sir, i have encountered this problem only previously also,
i have selected the arduino sdk, serial baud rate , com port as mentioned in the manual