Problem saving pic30.cof in card with MPLAB IDE
Posted: Fri Feb 12, 2010 11:36 am
Hello, I have a FLEX FULL board and a FLEX Multibus board and I'm trying the serial demo program which comes with Eclipse. This program sends the data '<H>' from the FLEX board to the PC by RS232.
I get the file pic30.cof compiling with Eclipse and I program the card using ICD2 in the Debugger mode of the MPLAB IDE. When press Run in the menu, I can see the chars '<H>' how to arrives at the PC using a terminal program. The system works correctly.
My problem comes when I use the Programmer mode of the MPLAB IDE. I select ICD2 and I Program the pic30.cof file. When I disconect the ICD2's cable, in my terminal program I can't see de chars '<H>'. It receives another chars that don't are nothing.
What I have to do to program the system and to work without having to be connected to the ICD2??
Thank you very much!!!
I get the file pic30.cof compiling with Eclipse and I program the card using ICD2 in the Debugger mode of the MPLAB IDE. When press Run in the menu, I can see the chars '<H>' how to arrives at the PC using a terminal program. The system works correctly.
My problem comes when I use the Programmer mode of the MPLAB IDE. I select ICD2 and I Program the pic30.cof file. When I disconect the ICD2's cable, in my terminal program I can't see de chars '<H>'. It receives another chars that don't are nothing.
What I have to do to program the system and to work without having to be connected to the ICD2??
Thank you very much!!!