Programing targets
Posted: Tue Feb 09, 2010 5:16 pm
Hello,
I have just bought a FLEX FULL target with a Multibus Base Daughter Board. I'm trying tu execute de serial demo program that comes with Eclipse to send data by the RS232 bus.
My problem is when I program the target using MPLAB IDE. If I use de Debugger Mode to program and later I press Run, I can see the data correctly with a terminal program. But when I disconect the ICD2 from the target, the data that I received are corrputed.
How can I program the target feasibly? It's possible to program the target with the Programmer mode of MPLAB IDE (menu option Programmer > Program)?
Thanks!
I have just bought a FLEX FULL target with a Multibus Base Daughter Board. I'm trying tu execute de serial demo program that comes with Eclipse to send data by the RS232 bus.
My problem is when I program the target using MPLAB IDE. If I use de Debugger Mode to program and later I press Run, I can see the data correctly with a terminal program. But when I disconect the ICD2 from the target, the data that I received are corrputed.
How can I program the target feasibly? It's possible to program the target with the Programmer mode of MPLAB IDE (menu option Programmer > Program)?
Thanks!
