Programing targets

Forum related to the FLEX boards

Moderator: paolo.gai

Locked
nestor
Newbie
Posts: 6
Joined: Tue Feb 09, 2010 5:03 pm

Programing targets

Post by nestor » Tue Feb 09, 2010 5:16 pm

Hello,

I have just bought a FLEX FULL target with a Multibus Base Daughter Board. I'm trying tu execute de serial demo program that comes with Eclipse to send data by the RS232 bus.

My problem is when I program the target using MPLAB IDE. If I use de Debugger Mode to program and later I press Run, I can see the data correctly with a terminal program. But when I disconect the ICD2 from the target, the data that I received are corrputed.

How can I program the target feasibly? It's possible to program the target with the Programmer mode of MPLAB IDE (menu option Programmer > Program)?

Thanks!

paolo.gai
Administrator
Posts: 875
Joined: Thu Dec 07, 2006 12:11 pm

Re: Programing targets

Post by paolo.gai » Thu Mar 04, 2010 12:43 pm

Sorry for the delay in the answer, the forum was misconfigured :-(

I'll reply in the next post...

Paolo

Locked