Page 1 of 1

Using the ADC with Flex-Scicos Toolbox

Posted: Mon Jun 09, 2008 9:49 am
by folghera
Hallo Everybody,

Anyone of you know to which pin of the Flex-Board is mapped the input Pin:1 of the FLEX-ADC Scicos-toolbox block (pin (of DSPIC33F) 25 or 32 or 6).

Also I can not find any information about the relationship between ports of the FLEX-Scicos toolbox and pins of the FLEX-Full board.

I think at the end I am missing some documentation..

Sincerely.

Michele Folgheraiter

Re:Using the ADC with Flex-Scicos Toolbox

Posted: Mon Jun 09, 2008 11:13 am
by francesco
Hi,

concerning the block ADC1 in Scicos, the PIN RC4 - AN19 is the corresponding pin in the dsPIC. This pin is located in the long pinhead connector and, looking the board with the power supply regulator at the bottom (long pinhead connector in the left side) is the 5th pin on the left beginning from the top (left extern side).

Within two weeks a new version of Erika will be available and a more detailed documentation for the use in combination with Scila/Scicos will be furnished.

Francesco