Programming FLEX with the Pickit 3

Forum related to the FLEX boards

Moderator: paolo.gai

Locked
resodad
Newbie
Posts: 1
Joined: Fri Nov 20, 2015 3:14 pm

Programming FLEX with the Pickit 3

Post by resodad » Mon Nov 23, 2015 7:38 pm

You can use the Microchip Pickit 3 to program the FLEX board:
Starting with the Pickit pin marked with a triangle, connect as follows:
pickit pin 1 to FLEX CON 6 pin 13 (MCLR)
pickit pin 2 to FLEX CON 6 pin 58 (3V3)
pickit pin 3 to FLEX CON 6 pin 60 (GND)
pickit pin 4 to FLEX CON 6 pin 54 (PGED1)
pickit pin 5 to FLEX CON 6 pin 52 (PGEC1)
pickit pin 6 to FLEX CON 6 pin not connected
A nice alternative to ICD3 and to programming the PIC18 for USB programming.
Sketch attached.
Cheers,
John
Attachments
pickit3 connecitons.png
pickit3 connecitons.png (748.42 KiB) Viewed 1667 times

Locked